»One product, 3 functions:
- For general applications, vector modulation IFD software
- For heavy torque performance, sensorless vector control VTC software
- For specific lift applications, vector modulation LIFT software
»Integrated filters on the full range in compliance with EN61800-3 2nd ed. about RFI emission limits
»Input contactor not necessary (doc. IEC 22G/109/NP draft of IEC61800-5 Safety requirements)
»Reduced dimensions up to 50%
»Intelligent cooling system
»Integrated braking chopper up to S30
»Lower motor noise with carrier frequency up to 16kHz (IFD and LIFT software)
»Motor PTC thermal probe control
»Easy commissioning with preset parameters for most common applications
»New control panel with 8 keys and large display (optional)
»Regulation of output frequency from 0 to 800Hz (120Hz for VTC software)
»In case of power failure, total control of the motor, down to 0 RPM
»Master-slave function for the operation of several motors connected to the same drive shaft.
»Automatic calibration for motor parameters’ recognition
»200% max torque
»PID regulator
»Skip frequency
»Integrated digital potentiometer
»Integrated multifunctional tester
»Integrated thermal protection of motor.
»Automatic DC braking
»Programmable multiple acceleration and deceleration ramps
»Feedback from tachometric dynamo or encoder
»8 programmable inputs
»4 programmable analog inputs 0-10Vdc, 0(4)-20mA
»2 programmable relays output
»1 open collector output
»Auxiliary voltage 24Vdc, 10Vdc
»2 programmable analog ouputs 0-10Vdc, 0(4)-20mA
»Serial communication RS485 with MODBUS RTU protocol
OPTIONS:
»Convert for MODBUS/Profibus-Device Net-CanBus
»Braking resistors
»Encoder card
»Kit remote keyboard operation
|
